STRUCTURAL DESIGN MANUAL

Introduction, Objective of this manual and General description of the Structural design of PANEL REY*

GENERAL INFORMATION
Concept
Basic components of the PANEL REY*

CONSTRUCTION SYSTEM
• Basic Tools

TABLE OF PROPERTIES AND CAPACITY TO SELECT COMPONENTS OF PANEL REY*
• Physical and Box and Back to Back Assembly Sectin Properties
• Loads uniformly distributed in beams with single spans
• Maximum allowable concentrated reactions and loads for beam webs
• Uniformly distributed allowable loads in lintels
• Load capacity under compression of box and back to back assembly section
• Inferior load wall frame studs
• Exterior load wall frame studs with wind action at 70 to 220 km./h.
• Frame studs for facade walls
• Structural screw capacities and gaps
• Capacity under pure tension of element for side joint
Download

GENERAL DETAILS OF STRUCTURE AND COATING
Download

PANEL REY* SYSTEM ARMORS
Download

GUIDE TO USE PANEL REY* CALCULATION TABLES (TUTOR)
• Selection of components acting as beams
• Selection of components acting as frame studs for exterior load walls
• Selection of components acting as studs to resist only pressure from the wind
• Selection of studs for interior load frames
• Selectio of studs for dividing walls frames (with no load)
• Selection of studs acting as lintels and closures
• Bracing and shear walls design
• Joint designs
• Anchoring
Download

APPENDIX I
Structural analysis guide

WIND DESIGN MANUAL
Download

SEISMIC DESIGN MANUAL
Download