 |
| |
|
 Metal Framing
 Download General PDF
|
The studs are made through a cold layering process using G-60 galvanized steel. Its design allows it to form light-weight structures that resist normal work loads for wall division like cabinets, mirrors, frames, Kitchen cabinets, etc.
We also have a line of Perfirey´s painted metal studs, made with G-60 galvanized steel that are covered with a layer of special additives and pigments for extra protection and resistance against the environment.
|
|
 Metal Studs
Are the principal elements to form a light-weigh structure. These are normally used in a vertical position.
Each Metal Stud is pre-punched at regular intervals specifically designed to facilitate electrical and
hydraulic installation (wiring, plumbing, etc.).
Download PDF
Up
 Metal track
Metal stud used normally in a horizontal position to secure and align metal studs to the floor and ceiling. These two combined are used in order to form the light structure of a division wall.
Download PDF
Up
 Furring channel
Hat-shaped stud, used for lining or furring masonry walls, cross furring gypsum wallboards, plaster soffits and ceilings. Its design also allows it to be placed under the cargo gutters.
Download PDF
Up
 Metal corner bead
Use to protect gypsum wall corners along with all exposed edges that could be damaged or bruised by doors, windows, or any abuse.
Metal stud made under the standards and norms of the ASTM – C1047.
Download PDF
Up
 Angle wall
This accessory is designed to be placed in the areas where the soffit of the wall is going to go. Its angle holds the soffit solidly against the walls, and sometimes it works as an auxiliary stud for some difficult walls. This metal stud is made according to the norms and regulations of ASTM – C1047.
Download PDF
Up
 “U” Channel
Indispensable stud for the construction of grid systems. It is used for bridging as it provides rigidity and support by carrying the loads derived form the materials used (ex: drywall, studs, screws, etc).
Download PDF
Up
 “J” Trim
Perfirey´s J-trim has been designed to provide maximum protection to drywall terminations and edges. J-Trims are normally, though not necessarily, placed horizontally at the lower part of the wall, separated 5mm from the ground to avoid contact with water in case of a spill. Made with caliber 26 galvanized steel under ASTM – C1047 standards.
Download PDF
Up
 “L” Trim
Perfirey´s L-trim is design to protect but mostly to provide a clean edge and finish at door and window openings, therefore keeping the total surface of the wallboard seemingly intact. This stud is made with galvanized steel caliber 26 according to ASTM-C1047 regulations.
Download PDF
Up
 Metal Resilient Channel
Panel Rey´s Resilient Channel is fabricated with 25 GA galvanized steel to diminish sound transmission.
Developed as one of the most efficient low cost method to reduce the effect of sound waves between gypsum drywall and the metal stud. Sound reduction of approximately 50% can be achieved in conjunction with Panel Rey´s gypsum board products.
Download PDF
IMPORTANT! To download those files you need the last version of Adobe Reader®
Get it, click here. 
|
|
| |
|
|
|
|
